No products in the cart.
Online UPS 6KVA
| Model | PX6K | |
| Rated power | 6KVA/5400W | |
| AC Input | Input system | Single phase(L/N+PE) |
| Nominal voltage | HV: 208/220/230/240Vac | |
| LV: 100/110/120/127Vac | ||
| Frequency | 50/60Hz | |
| Voltage range | HV: 90-300VAC±5VAC | |
| LV: 60-145VAC±3VAC | ||
| Frequency range | (40-70)±0.5Hz | |
| Input power factor | >0.99 | |
| Bypass Voltage range | HV: 115-285VACx(1±3%) | |
| LV: 60-145VAC±3VACx(1±3%) | ||
| Battery Input | Nominal Voltage | 192V |
| Battery Capacity & Quantity | 12V/7AH*16pcs | |
| Backup Time | Half loaded≥8 minutes | |
| Full loaded≥3 minutes(standard) | ||
| Battery charger time | Charger to 90% battery capacity in 5 hours(standard) Dependent on the capacity of external batteries(long backup time) | |
| AC Output | Output system | Single phase(L/N+PE) |
| Inverter Mode Output voltage | HV: 208/220/230/240Vac±2% | |
| LV: 100/110/120/127Vac±2% | ||
| Waveform | Pure Sine Wave | |
| THD<3%(linear load) | ||
| THD<7%(nonlinear load) | ||
| Output frequency | 50/60±4Hz(Sync mode) | |
| 50/60Hz±1%(Fix Freq.mode) | ||
| Dynamic voltage transient range | <9% | |
| Dynamic transient Recovery | <100ms | |
| Overload capability | 105~125%≥60s;126~150%≥30s The recover point is 70% | |
| Crest Ratio | 3:1 | |
| Transfer time | Battery <-> Line Mode: 0ms | |
| Communications | RS232 RS485(optional),Dry contact(optional) | |
| Alarm Function | AC/DC input under abnormal,overload condition and Inverter problems | |
| Protection Function | AC input or output above or below the range of voltage, overload, over temperature and short circuit protection | |
| Noise | <50dB | |
| 模型 | ON6K | |
| 额定功率 | 6千伏安/6000瓦 | |
| 交流输入 | 输入系统 | 单相(L/N+PE) |
| 标称电压 | 高压：208/220/230/240Vac | |
| 低压：100/110/120/127Vac | ||
| 频率 | 50/60赫兹 | |
| 电压范围 | 高压：90-300VAC±5VAC | |
| 低压：60-145VAC±3VAC | ||
| 频率范围 | （40-70）±0.5赫兹 | |
| 输入功率因数 | >0.99 | |
| 旁路电压范围 | 高压：115-285VACx(1±3%) | |
| 低压：60-145VAC±3VACx(1±3%) | ||
| 電池輸入 | 标称电压 | 192 伏 |
| 电池容量和数量 | 12V/7AH*16个 | |
| 备份时间 | 半载≥8分钟 | |
| 满载≥3分钟（标准） | ||
| 电池充电时间 | 充电时间为 5 小时至 90%（标准）取决于外部电池的容量（长备用时间） | |
| 交流输出 | 输出系统 | 单相(L/N+PE) |
| 逆变模式输出电压 | 高压：208/220/230/240Vac±2% | |
| 低压：100/110/120/127Vac±2% | ||
| 波形 | 纯正弦波 | |
| THD<3%（线性负载） | ||
| THD<7%（非线性负载） | ||
| 输出频率 | 50/60±4Hz（同步模式） | |
| 50/60Hz±1%(固定频率模式) | ||
| 动态电压瞬态范围 | <9％ | |
| 动态瞬态恢复 | <100毫秒 | |
| 过载能力 | 105~125%≥60s;126~150%≥30s 恢复点70% | |
| 波峰比 | 3：1 | |
| 转乘时间 | 电池<->线路模式：0ms | |
| 通讯 | RS232 RS485(可选)，干接点(可选) | |
| 报警功能 | 交流/直流输入异常、过载及逆变器问题 | |
| 保护功能 | 交流输入或输出电压高于或低于范围、过载、过温和短路保护 | |
| 噪音 | <50分贝 | |
Reviews
There are no reviews yet.